Tabla de contenido
Publicidad
IMPORTANT NOTICE
Please read the instructions carefully before installing the door operator. We are not responsible for any loss or damage
caused if the following precautions are not followed.
-
Watch the movement of the door and keep anyone away until the door is completely open or closed.
-
Be careful when using the manual release as an open door can fall quickly due to a weak or broken spring or being out
of balance.
-
Examine frequently the installation, especially cables, springs and hardware for signs of fatigue, damage or imbalance.
Do not use the operator if a repair or adjustment is necessary.
-
Each month, check that the movement is reversed when the door contacts an object 50mm above the floor.
-
Before installing the transmission, check that the door is in a good mechanical condition and remove all unnecessary
ropes or chains and disable any equipment such as locks that are not necessary for the operation of the motor.
-
Install the actuator for manual unlocking at a height of less than 1.8m.
-
Permanently affix entrapment warning labels to a visible location.
-
Permanently affix the manual release label next to its actuator.
-
After installation, make sure that parts of the door do not extend over public sidewalks or road.
-
After installation, make sure that the operator stops the opening movement when loading a mass of 20 kg cantered on
the lower edge of the door.
-
Make sure the door is used at least every 3 months.
-
Maintenance should be performed by a professional. Non-professionals are not allowed to adjust the door or operator.
-
To ensure that the door is properly balanced after maintenance, it must be possible to move the door in any position
up or down with a force of less than 20N.
-
Do not allow anyone to stand under the door during maintenance to prevent the risk of an accident due to a falling
door.
-
Before installation, make sure that stress limit to tension of the steel cable, chain and belt is 6 times greater than the
actual load and that the diameter of the cable drum is 20 times that of the steel cable.
-
The number of operator durability cycles is 20,000.
-
The operator is not intended for lockable doors.
3
MASTER INGENIEROS S.A. Avenida del Descubrimiento, Parc 16/8, 30820 Alcantarilla, Murcia (ESPAÑA)
©2023 MASTER INGENIEROS. All rights reserved.
MICOMDOOR® is a registered trademark of MASTER INGENIEROS S.A.
www.masteringenieros.com
MICOMDOOR®
MA000277-ML-01a
MICOMDOOR®
Publicidad
Tabla de contenido
