2.2 - LIST OF CONSTITUENT PARTS
"Figure 1" shows the main parts making up the NUUR.
1
A
B
C
J1
J2
A Boom support
B Gearmotor containment box
C Cover
D Electronic control and command unit
E Boom
F Locking/unlocking key
- 48 - ENGLISH
D
E
J3
J4
J5
J6
J7
J8
J9
Z1
Z2
Z3
Z4
Z5
Z6
B1 B2
A
F
B
3 - INSTALLATION
3.1 - PRE-INSTALLATION CHECKS
m
The installation must be carried out by qualified
personnel in compliance with the current legislation,
standards and regulations, and with the instructions provided
in this manual.
Before proceeding with the product's installation, it is necessary to:
• check the integrity of the supply
• check that all the materials are in good working order and suited
to the intended use
• check whether it is possible to observe the operating limits
specified in the paragraph "Product usage limits"
• check that the installation location is compatible with the overall
clearance of the product (see "Figure 2")
• check that the surface chosen for installing the boom gate is solid
and can ensure stable anchorage
• make sure that the installation area is not subject to flooding; if
necessary, the product must be installed appropriately raised
above ground level
• check that the space surrounding the boom gate allows for
executing the manual manoeuvres easily and safely
• check that there are no obstacles along the boom's path capable
of hampering the opening and closing manoeuvres
• check that each device to be installed lies in a position that is
protected against the risk of accidental impact.
• verify that the mounting positions of the various devices are
protected against impacts and that the mounting surfaces are
sufficiently sturdy
• prevent any parts of the automation from being immersed in
water or other liquids
• keep the product away from heat sources and open flames and
acid, saline or potentially explosive atmospheres; these may
damage the product and cause malfunctions or dangerous
situations
• connect the control unit to an electricity supply line equipped with
a safety earthing system
3.2 - PRODUCT USAGE LIMITS
Before proceeding with the product's installation, it is necessary to:
• check that all the values appearing in the "TECHNICAL
SPECIFICATIONS" chapter are compatible with the intended use
• check that all limitations, conditions and warnings appearing in
this manual can be fully observed.