V2 NUUR4 Manual De Instrucciones página 77

4. apply the adhesive led strip on the boom and insert it in the slot
m
ATTENTION: if the led strip must be shortened, cut where
the symbol is shown
5. insert the wiring using the hole on the cabinet
NUUR 4
36
NUUR 6
m
leave a bit of cable inside the boom support, so that the
boom can be rotated without causing any tension along the
cable.
6. connect the lights cable to the SYNCLUX module (for installation,
follow the specific instructions supplied with the module)
7. fasten the cable inside the cabinet using the ties
8. assemble the bumper rubber as described in chapter 3.8
9. insert the boom and fasten it with the support and cover
15.4 - PHOTOCELLS
You can install one of the photocells (code 13S017) inside the barrier
mechanism in the space provided.
To perform the installation:
1. remove the card of the photocell (A) from its box by levering with a
screwdriver. Take care not to damage the electrical components.
2. open the box prepared for the photocells (B) provided
60
A
3. remove the RX electronics and insert it into the transparent shell
supplied
4. secure the card into the back of the box
5. drill through the rubber part (C) prepared for passing the cables
6. pass the photocell connection cable through the rubber part
7. connect it to the photocell card
61
B
8. close the box with the cover, blocking the rubber part inside its
housing
9. hook the box over the lens (D) inside the cabinet, sliding it from
the top downwards
62
m
For further information, refer to the instruction manual
for the photocells.
B
A
C
D
ENGLISH - 75 -