Publicidad
Idiomas disponibles
Idiomas disponibles
DOOR REVERSE
The side at which the door opens can be changed, from the right side (as supplied) to the left side,
if the installation site requires.
Warning! When reversing the door, the appliance must not be connected to the mains. Ensure that
the plug is removed from the mains socket.
Tools and parts you will need are as below:
Note: Before you start lay the refrigerator on its back in order to gain access to the base, you should
rest it on soft foam packaging or similar material to foam packaging or similar material to avoid
damaging the backboard of the refrigerator. To reverse the door, the following steps are generally
recommended.
1. Stand the refrigerator upright. Open the upper door to take out all door racks (to avoid racks
damaged) and then close the door.
2. Open part ① on top of the upper door and then disconnect electrical connector. Take down part
② and put it back to the plastic bag.
3. Remove part ① and the screws ②. Put them back to the plastic bag.
Note: Please hold the upper door by hand during step 3 to prevent door dropping.
4. Remove the upper door and place it on a smooth surface with its panel upwards. Loose screws
③ , detach part ② and part ① , then install part ① and another part ②(in the plastic bag)to
the left side with screws ③. Put part ② just detached back to plastic bag.
5. Exchange wire from the right to left slot of refrigerator body.
6. Loose screws used to fix the middle hinge and remove middle hinge, then remove the lower
door.
Step 2
Step 3
left upper hinge
door block,
cover
left ref
51
door holder,
left ref
Step 4
Publicidad
