Publicidad
Idiomas disponibles
Idiomas disponibles
35
USER INTERFACE
SPS (SUGGESTED PARAMETER SETUP)
The Intelect® Legend 2 has a Suggested Parameter Setup (SPS) icon that is a series of protocol presets where the clinical
benefit and target condition are selected by the user, and the suggested algorithm will select the parameter settings. All
settings can be edited to suit appropriate patient treatment prescription and patient comfort.
Please note, the referenced SPS parameters are suggestions/guidelines only, and are based on historical experience obtained
for the device within the clinical setting.
COMPLETE THE FOLLOWING STEPS TO START AN SPS PROTOCOL:
1. Select SPS from the Home Screen
2. Select Clinical Benefit
3. Select target
4. Select MODALITY/WAVEFORM
5. SET UP TREATMENT
On the treatment review screen the suggested treatment settings are displayed and you can adjust parameters to desired
level.
Never start with intensity adjustment – first adjust all other parameters and set Intensity just before starting treatment
Pressing the save button will save the treatment as a custom protocol which can be named by the user
Pressing the Assign to button will give two buttons as seen below
- Assign to: this button assigns the treatment data to a specific treatment data file which can be named by the user
- Open pain scale: this button opens up the pain scale so the pre-treatment pain can be recorded
6. START TREATMENT
Press the START button
INTELECT
LEGEND 2 USER MANUAL
®
EN
Publicidad
