Publicidad
Idiomas disponibles
Idiomas disponibles
Never use engine
or carburetor
cleaner
products
in the fuel tank or permanent
damage
may occur.
TO START
ENGINE
When
starting
the engine
for the first time
or if the engine
has run out of fuel, it will
take extra cranking
time to move fuel from
the tank to the engine.
1.
Be sure freewheel
control
is in the
transmission
engaged
position.
2.
Sit on seat in operating
position,
depress
clutch/brake
pedal and set
parking
brake.
3.
Place motion
control
lever in neutral
(N) position.
4.
Move attachment
clutch
to disengaged
position.
5.
Move throttle
control
to choke position.
NOTE:
Before
starting,
read the warm
and cold starting
procedures
below.
6.
Insert
key into ignition
and turn key
clockwise
to start position
and release
key as soon as engine
starts.
Do
not run starter
continuously
for more
than fifteen
seconds
per minute.
If the
engine
does not start after several
attempts,
move throttle
control
to fast
position,
wait a few minutes
and try
again.
If engine
still does not start,
move the throttle
control
back to the
choke
position
and retry.
WARM
WEATHER
STARTING
(50 ° F and
above)
7.
When
engine
starts,
move the throttle
control
to the fast position.
• The attachments
and ground
drive can
now be used. If the engine
does not
accept
the load, restart
the engine
and
allow it to warm
up for one minute
using
the choke as described
above.
COLD WEATHER
STARTING
( 50 ° F and
below)
7.
When
engine
starts,
leave throttle
control
in choke position
until engine
warms
up and begins
to run roughly.
Once
rough running
begins,
imme-
diately
move the throttle
control
to the
fast position.
Engine
warm-up
may
take from several
seconds
to several
minutes
(the colder
the temperature,
the longer
the warm-up).
AUTOMATIC TRANSMISSION
WARM UP
Before driving the unit in cold weather,
the transmission
should be warmed up as
follows:
1.
Be sure the tractor
is on level ground.
2.
Place
the motion
control
lever in
neutral.
Release
the parking
brake
and let the clutch/brake
slowly
return
to operating
position.
3.
Allow one minute for transmission
to
warm
up. This can be done during
the engine
warm
up period.
• The attachments
can also be used dur-
ing the engine
warm-up
period
after the
transmission
has been warmed
up.
NOTE:
If at a high altitude
(above
3000
feet) or in cold temperatures
(below
32 F)
the carburetor
fuel mixture
may need to
be adjusted
for best engine
performance
(see "TO ADJUST
CARBURETOR"
in the
Service
and Adjustments
section
of this
manual).
RGE
TRANSMISSION
CAUTION:
Never engage
or dis-
engage
freewheel
lever while
the engine
is running.
To ensure
proper
operation
and per-
formance,
it is recommended
that the
transmission
be purged
before
operating
tractor
for the first time. This procedure
will
remove
any trapped
air inside the trans-
mission
which
may have developed
during
shipping
of your tractor.
IMPORTANT:
Should
your transmission
require
removal
for service
or replace-
ment,
it should
be purged
after reinstall-
ation before
operating
the tractor.
1.
Place
tractor
safely on a level surface
-
that is clear of objects
and open - with
engine
off and parking
brake set.
2.
Disengage
transmission
by placing
freewheel
control
in disengaged
posi-
tion (See "TO TRANSPORT"
in this
section
of manual).
3.
Sitting
in the tractor
seat, start engine.
After the engine
is running,
move
throttle
control
to slow position.
With
motion
control
lever in neutral
(N)
position,
slowly
disengage
clutch/brake
_pedal.
AUTION:
At any time, during step
4, there
may be movement
of the drive
wheels.
4.
Move motion
control
lever to full
forward
position
and hold for five (5)
seconds.
Move lever to full reverse
position
and hold for five (5) seconds.
Repeat
this procedure
three (3) times.
5.
Move motion
control
lever to neutral
(N) position.
Shutoff
engine
and set
parking
brake.
16
Publicidad
