Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART:
PROBLEM
Mower
blades
will
not rotate
Poor grass
discharge
Headlight(s)
not
working
(if so equipped)
Battery will not
charge
Loss of drive
Engine
"backfires"
when turning
engine
"OFF"
CAUSE
1.
Obstruction
in clutch
mechanism•
2.
Worn/damaged
mower drive
belt.
3.
Frozen
idler pulley•
4.
Frozen
blade mandrel•
1. Engine speed too slow.
2. Travel speed too fast.
3. Wet grass.
4.
Mower deck not level.
5.
Low/uneven
tire air pressure.
6.
Worn,
bent or loose blade.
7.
Buildup
of grass,
leaves
and
trash under mower.
8.
Mower drive belt worn.
9.
Blades
improperly
installed.
10. Improper
blades
used.
11
•Clogged
mower
deck vent
holes from buildup
of grass,
leaves,
and trash around
mandrels.
1.
Switch
is "OFF".
2.
Bulb(s) or lamp(s) burned out.
3.
Faulty
light switch•
4.
Loose
or damaged
wiring•
5.
Blown fuse.
1.
Bad battery
cell(s).
2.
Poor cable
connections.
3.
Faulty
regulator
(if so equipped).
4.
Faulty alternator.
1.
Freewheel
control
in
"disengaged"
position.
2.
Motion
drive belt worn,
damaged,
or broken.
3. Air trapped
in transmission
during
shipment
or servicing.
•
Engine
throttle
control
not set
between
half and full speed
(fast) position
before
stopping
engine•
CORRECTION
1.
Remove
obstruction•
2.
Replace
mower drive belt•
3.
Replace
idler pulley•
4.
Contact
our authorized
service
center/department.
1.
Place throttle control in "FAST
position.
2.
Shift to slower
speed.
3. Allow
grass to dry before
mowing.
4.
Level mower
deck.
5.
Check
tires for proper
air
pressure.
6.
Replace/sharpen
blade.
Tighten
blade bolt.
7.
Clean underside
of mower
housing.
8.
Replace
mower drive belt.
9.
Reinstall
blades
sharp
edge
down.
10. Replace
with blades
listed
in this manual.
11. Clean around
mandrels
to
open vent holes.
1. Turn switch "ON".
2.
Replace
bulb(s)
or lamp(s).
3.
Check/replace
light switch.
4.
Check wiring and connections.
5.
Replace
fuse.
1.
Replace
battery.
2.
Check/clean
all connections.
3.
Replace
regulator.
4.
Replace
alternator.
1.
Place freewheel
control
in
"engaged"
position.
2.
Replace
motion
drive belt.
3.
Purge transmission.
Move throttle
control
between
half and full speed
(fast) position
before
stopping
engine•
•
30
Publicidad
