Southern States SO19H42LT Manual Del Operador página 29

TROUBLESHOOTING CHART:
PROBLEM
Loss of power
(continued)
Excessive
vibration
Engine dies when
tractor is shifted
into reverse
Engine continues
to run when oper-
ator leaves seat
with attachment
clutch engaged
Poor cut - uneven
CAUSE
5. Low oil level/dirty oil.
6. Faulty spark plug.
7. Dirty fuel filter.
8. Stale or dirty fuel.
9. Water in fuel.
10. Spark plug wire loose.
11. Dirty engine air screen/fins.
12. Dirty/clogged muffler.
13. Loose or damaged wiring.
14. Carburetor out of adjustment
15. Engine valves out of
adjustment.
1. Worn, bent or loose blade.
2. Bent blade mandrel.
3. Loose/damaged part(s).
.
Reverse operation system
(ROS) is not "ON" while
mower or other attachment
is engaged.
1. Faulty operator-safety
presence control system.
.
2.
3.
4.
5.
Worn, bent or loose blade.
Mower deck not level.
Buildup of grass, leaves, and
trash under mower.
Bent blade mandrel.
Clogged mower deck vent
from build-up of grass, leaves,
and trash around mandrels.
CORRECTION
5. Check oil level/change oil.
6. Clean and regap or change
spark plug.
7. Replace fuel filter.
8. Empty fuel tank and refill tank
with fresh, clean gasoline.
9. Empty fuel tank and car-
buretor, refill tank with fresh
gasoline and replace fuel filter.
10. Connect and tighten spark
plug wire.
11. Clean engine air screen/fins
12. Clean/replace muffler.
13. Check all wiring.
14. See "To Adjust Carburetor" in
Service and Adjustments
section.
15. Contact our authorized
service center/department.
1. Replace blade. Tighten
blade bolt.
2. Contact our authorized
service center/department.
3. Tighten loose part(s).
Replace damaged parts.
1. Turn ignition key to
ROS "ON" position.
See Operation section.
.
Check wiring, switches and
connections. If not corrected
contact our authorized
service center/department.
1. Replace blade. Tighten
blade bolt.
2. Level mower deck.
3. Clean underside of mower
housing.
4. Contact our authorized
service center/department.
5. Clean around mandrels to
open vent holes.
29