Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE HOB, BURNERS AND ACCESSORIES
Avoid leaving the components dirty for long and,
periodically,according to the intensity of work (if
necessary daily),proceed as indicated below:
1-Switch the appliance off and leave it to cool.
2-Remove the grill, the burner cap (A) and the
burner (B).
3 - Put them to soak in hot water with dishwasher
soap.
4-Wash with a normal sponge and if necessary a
scourer to remove any dirt thoroughly.
5-Check that the holes of the burner cap (A) are al-
ways completely clear for the regular flow of
gas. To remove possible dirt, insert a metal rod
wire) into the hole and slide it through until it is
thoroughly clean.
6-Check the burner (B) ignition slot (cutoff ) is al-
ways completely clear for the normal flow of
gas. To remove any dirt, insert a blade like a
trimming knife in the slot, sliding it around until
it is thoroughly clean.
7 - Carefully clean all the connecting parts between
the burner cap (A) and the burner (B). If neces-
sary use a steel wire brush for mechanics.
8 - Clean every part of the hob with a suitable de-
greaser.
9 - Dry the surfaces and reassemble the parts.For
the correct assembly of the burner (B) and
burner cap (A), follow the directions given in the
illustration.
10-.Turn on the burners for a few minutes to en-
sure a thorough drying and thus avoiding the
formation of rust.
CHECKING GAS PRESSURE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Undo the screw (D) of the pressure connection.
5 - Connect the pressure gauge (E) to the pressure
test point (F).
6 - Turn the gas supply tap back on.
7 - Light all the burners and turn the knobs to the
full flame setting (see page 7), then check that
the pressure reading complies with the values
provided in the table at the back of the manual.
8 - Turn off the burners, disconnect the pressure
gauge and return all components to their initial
condition on completion of the operation.
Caution - warning
Do not wash cast iron parts such as the
burners, burner caps and grills in a dish-
washer.
Caution - warning
Never pour water or allow dirt to fall into
the burner as this will cause the burner to
malfunction or block the nozzle.
C
A
B
C
- 9 -
A
B
IDM-39610802000.tif
E
IDM-39610802100.tif
IT
GB
DE
FR
ES
F
D
English
Publicidad
