Angelo Po 04WFAAV Manual De Uso E Instalación página 32

The appliance has been tested before being put
into service. The information provided below is in-
tended to assist in the identification and correction
of any anomalies and malfunctions which might oc-
cur during use.
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Fault
Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
IT IT
The pilot light ignites but the burn-
er remains off.
GB GB
The flame is yellow.
DE DE
Burner control knob is stiff.
FR
FR
ES ES
English
FAULT
TROUBLESHOOTING
Occasional leak because flame
The spark ignition devices are not
Air in pipelines due to long period
The thermocouple has not
warmed up enough.
Burner dirty, heat exchange pipes
clogged, condensation drips.
Gas control valve malfunction.
Important
For all requirements contact the agents or
the headquarters of Angelo Po which can
be found in the contacts section of the web-
site http://www.angelopo.com.
Causes
has gone out.
working.
out of use.
- 10 -
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices
are in good working order. Light
by hand with a naked light.
Important
Contact the after-sales service.
Make more attempts to light the
flame.
Make more attempts to light the
flame.
Check the condition of the ther-
mostat and activate any ignition
enabling device.
Important
Contact the after-sales service.
Important
Contact the after-sales service.
6