Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and operation
CAUTION
Do not operate this pump
without personal protective
equipment. Pump can
generate noise levels above
85 dBa that could result in hearing loss.
Failure to comply could result in
personal injury.
WARNING
Do not exceed lowest pressure rating of
any component in system.
Failure to comply may result in
serious injury or death.
WARNING
Do not operate pump with broken,
missing or defective parts. Replace
defective parts prior to operation.
Failure to comply may result in
serious injury or death.
WARNING
Do not operate with leakage in system.
Disconnect air to motor.
Failure to comply may results in
serious injury.
Bench test
NOTE
Perform the following procedures at a
pressure not to exceed 20 psi (1.4 bar).
With air pressure at zero:
1 Connect air to inlet of air motor.
2 Slowly supply air pressure to pump
motor.
3 Pump should cycle. If pump does not
cycle, refer to Troubleshooting (page 16)
for details.
Priming
With air pressure at zero:
4 Connect product hose to material outlet.
5 Direct hose into an appropriate collection
container.
6 Place pump in product.
7 Slowly supply air pressure to pump
motor.
8 Allow pump to cycle slowly until system
and product is free of air.
9 If pump does not prime, refer to
Troubleshooting (page 16) for details.
14
Stall test
With air pressure at zero:
10 Attach a control valve to outlet hose of
pump.
11 Set air pressure to 35 psi (2.4 bar).
12 Operate control valve into a container.
13 Allow pump to cycle until system and
product is once again free of air.
14 Shut off control valve.
15 Set air pressure to 100 psi (7 bar).
16 Visually inspect pump for external leaks.
17 Pump should not cycle. If pump does not
stall, refer to Troubleshooting (page 16)
for details.
Leakage
18 Check motor for air leakage.
19 If motor leaks, refer to 670432 for
details.
Publicidad
