Changing Location; Connection To Power Supply; Operating Instructions; Control Panel And Display - Auxilab MEDIBAS+ Manual De Uso

4.3 Changing location

Once the centrifuge has been installed, it should not be moved. In case of being necessary
to change location, the new location should be solid, horizontal, free of movements and
vibration and the centrifuge should be perfectly level.

4.4 Connection to power supply

The power supply connected to the centrifuge must be properly grounded. Check the
cable used meet with the safety requirements in your country or region. The inlet voltage and
frequency should match with the requirements indicated in the plate of specifications of the
centrifuge (220V / 50-60Hz / 8A). Please, use the power cable supplied with the equipment to
connect the centrifuge to the power net.
The equipment will be turned on with the switch on position "︱" and turned off with the
switch on position "O".

5. Operating instructions

5.1 Control panel and display

14. Lid open button
15. Start/Stop LED
2-1 Start/Stop button
16. Short-spin button (Flash)
17. Parameter setting knob
Figure 4: Control panel
- 38 -