OMFB RADAR II Manual De Instalacion Y Uso página 42

"RADAR II"
USER MANUAL
101050
To deactivate the Emergency Stop function (indicated by a continuous buzzer sound emitted
by the receiver) and restore system operation, press the green Reset button.
6.2 Emergency Stop engaged by the Receiver
To activate the Emergency Stop function from the receiver press the mushroom-head STOP
button (the buzzer inside the receiver emits a continuous sound).
To restore system operation, release the push-button by turning it clockwise and press
the green Start button.
7. P
roGramminG ProCedures
7.1 Programming
This procedure is necessary if you have received a transmitter and receiver(s) separately.
Before using a new TXF transmitter, communication has to be created between the
transmitter and the receiver(s).
To do this please follow the below described programming procedure.
LEARNING ZONE
ATTENTION: make sure the receivers have not already been programmed, if they have,
cancel the program and reprogram with the new transmitter.
1. Power up the receiver (insert the battery disconnector and any other switch that may be
installed in series with the receiver power supply);
2. On the transmitter: make sure the TX LED lights up when a function button is pressed
in columns A, B, C;
3. On the receiver: press the red emergency mushroom-head button: the buzzer inside
begins to emit a continuous sound;
4. On the receiver: put a magnet next to the "Learning Zone": the buzzer inside
the receiver will emit an intermittent sound;
pag.42
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it