Publicidad
Idiomas disponibles
Idiomas disponibles
"RADAR II"
8.2 Functional testing procedure of the RADAR II receiver unit
Power up the receiver unit
Press the red mushroom-head button
Yes
Disengage the red mushroom
head button and press the
green button on the receiver unit
Test the manual commands
by pressing the push-buttons
on the receiver one by one
8.3 REED programming testing procedure
Shut off and switch on
again the electrical power
supply to the receiver unit
Press the red mushroom-head button
Yes
Place the left side of the TXF transmitter
next to the Learning Zone of the receiver
Repeat the steps from the beginning, shutting off
the power supply and switching it back on after
approximately 20 seconds: if you still return to this
box, request a return indicating "Possible problems
Functional test procedure for RADAR II receiver unit
Start
Make sure the receiver is correctly powered (i.e.
battery disconnector engaged, fuses intact, any
additional circuit breakers engaged) and that the
positive and negative poles on the board inside
No
the receiver receive the correct supply voltage
Does the receiver
emit a continuous
Make sure that the vehicle batteries are charged
sound?
(start the vehicle if necessary) and that there are
no breaks or short-circuits in the power line.
Yes
Request a return indicating
Does the receiver
"Possible problems on the
still emit a sound?
Emergency command"
No
REED Programming Test Procedure
Start
Go to the Transmitter
No
Does the receiver
Go to the Functional test procedure
emit a continuous
for RADAR II receiver unit
sound?
Within 10 seconds press a push-
Does the
Yes
button on the transmitter whose
receiver emit
operation has already been
an intermittent
verified using the Transmitter
sound?
No
with programming"
O.M.F.B. S.p.A. Hydraulic Components
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it
USER MANUAL
between 9 V and 28 V.
Are the
Yes
manual
commands
all working?
No
Go to the Power outputs test
procedure
No
Test Procedure
Test Procedure
pag.45
We reserve the right to make any changes without notice.
Request a return indicating
"Possible problems on the
power supply line"
Yes
Does the receiver
emit a continuous
sound?
Sì
Go to the Programmin test
procedure
Yes
Are all the
transmitter
End
commands
working?
Test the operation of the
transmitter commands
Disengage the red mushroom-
head button and press the
green button on the
receiver unit
Yes
Does the receiver
emit a continuous
sound?
No
101050
Publicidad
