OMFB RADAR II Manual De Instalacion Y Uso página 43

"RADAR II"
USER MANUAL 101050
5. On the transmitter: press one of the function buttons (channel 1 Up/Down or channel 2
Up/Down) in the column on which you wish to program the receiver (A, B or C).
6. On the receiver: the sound issued by the buzzer returns;
7. On the receiver: release by turning the red emergency mushroom-head button;
8. On the receiver: press the green button;
9. Make sure all functions connected to the radio remote control system are correctly
activated.
REED PROGRAMMING
The REED programming procedure is to be used with both the TXF transmitter and with the
RADAR II MIDI transmitter: in the case of the MIDI transmitter, there is no need to press
the push-buttons "A", "B" or "C" which are not included since it is able to control only up
to 4 channels.
RESET OR PROGRAM CANCELLING PROCEDURE
Each receiver stores up to 5 distinct transmitter codes. When the memory is full, the receiver
signals it by emitting an intermittent high frequency sound. To reset the memory, proceed
as for programming up to step 4 and keep the transmitter at hand. When the continuous
beep switches to alternating beeps, within 5 seconds the alternating beeps will emit a
sound at a different frequency. Now, after releasing the emergency button, press the green
button on the receiver.
pag.43
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it