Publicidad
Idiomas disponibles
Idiomas disponibles
The selection of menus is always shown
in shortened form in these operating
instructions:
Navigate to the Care > Descaling menu.
ƒ
Care
Exit
Rinse coffee system
Rinse milk system
Rinse milk system
Clean milk system
Descale appliance
Water filter
Exit allows you to leave a menu and access
the Ready display.
3 First steps
3.1 Unpacking the
appliance
Remove the packaging material, the adhe-
sive strips and the protective films from
the appliance. Please keep the original
packaging.
The appliance has been tested in the
factory to ensure that it functions perfectly.
Therefore, the appliance may still contain
traces of coffee and water.
3.2 Setting up the
appliance
Set up the appliance in a dry room.
ƒ
Set up the appliance on a stable, flat and
ƒ
dry surface. The surface may not be hot.
The appliance may not be placed in the
vicinity of sinks or the like.
Set up the appliance at a sufficient
ƒ
distance (approx. 10 cm) from the wall
and other objects. The space above the
appliance should be at least 20 cm.
Route the power cable so it does not lie
ƒ
over edges or cannot be damaged by
hot surfaces.
3.3 Connecting the
appliance
Only connect the appliance to a properly
installed earthing contact socket. The
earthing contact socket must be protected
by a fuse with a rating of at least 10 A.
3.4 Switching on the appli-
ance for the first time
Place a vessel under the height-adjust-
ƒ
able outlet. The distance between the
outlet and the vessel should be as small
as possible.
Switch on the appliance with the "On/
ƒ
Off" button.
Start the setup by pressing the "rotary
ƒ
regulator" briefly.
Set the language.
ƒ
Set the water hardness. You can
ƒ
determine the water hardness with
the enclosed test strip. Observe the
instructions on the test strip and the
information in the table in section 8.10,
page 30.
Remove the water tank. Rinse out the
ƒ
water tank with clean tap water.
Fill the water tank with fresh, cold tap
ƒ
water and insert it. Observe the instruc-
tions in section 4.1, page 23.
Fill the bean container with coffee
ƒ
beans. Observe the instructions in
section 4.2, page 24. Alternatively you
can fill coffee powder into the ground
coffee chute. Observe the instructions in
section 4.3, page 24.
Prepare the first two beverages. Observe
ƒ
the instructions in section 5, page 25.
Pour the first two beverages away after
ƒ
initial start-up.
4 Preparing to make
beverages
4.1 Filling with tap water
The quality of the tap water largely deter-
mines the flavour of the coffee. Fill the
water tank only with fresh, cold tap water
that has not been carbonated. Change the
tap water on a daily basis. Please observe
the maximum filling level.
First steps
23
Publicidad
