HTW UNIG -AAM35DA-R290 Manual De Usuario E Instalacion página 38

USER AND INSTALLATION MANUAL
1. SAFETY INSTRUCTIONS
• Do not use the product and contact the retailer for advice, if damage has occurred to the unit which
may have compromised the refrigerant system.
• Any repairs or maintenance must only be carried out on the unit by a suitably qualified engineer.
Before opening and servicing the unit the authorized engineer must be in possession of a copy of the
manufacturer's service manual and must follow the safety information contained within it to ensure all
hazards are minimized.
• The refrigerant system should not be perforated or punctured.
ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS
• Do not cover or restrict the airflow from the outlet or inlet grills.
• Keep the filters clean . Under normal conditions , filters should only need cleaning once every three
weeks ( approximately ) . Since the filters remove airborne particles , more frequent cleaning maybe
necessary , depending on the air quality.
• For the initial start-up set the fan speed to maximum and the thermostat to 4-5 degree lower than the
current temperature . After , set the fan switch to low and set the thermostat to your desired setting.
• To protect the unit , we recommend not using the cool mode when the ambient temperature is higher
than 35ºC.
•
• NOTE : Some pictures and information may vary from the final product . This is due to continual
product improvement.
36

MONOBLOCK UNIG