Ega Master EGATRONIK 51735 Manual De Instrucciones página 34

DC VOLTAGE MEASUREMENT (PICTURE 2)
1) Insert the red test lead into the
2) Turn the function dial to the
3) Connect the test leads with the measured load or power supply in parallel.
4) Read the voltage value on the display.
Note:
- Do not input voltage above 1000V. Although it is possible to measure higher voltage, it may
damage the meter.
- When measuring at 600mV range, use "REL" measurement mode to get accurate readings.
Short-circuit the test leads, and then short press the REL ZERO button. Read the measured
voltage after the voltage of the shortcircuited test leads is automatically subtracted.
- Be cautious to avoid electric shock when measuring high voltage.
- After completing the measurement, disconnect the test leads from the circuit under test.
- When the measured voltage is above 30V, the LCD will display the high voltage alarm prompt
" ".
LOZ MEASUREMENT (PICTURE 3)
LoZ ACV Measurement
1) Insert the red test lead into
2) Turn the function dial to the LoZ V~ position, and connect the test leads with the measured
load or power supply in parallel.
LoZ ACV Frequency Measurement
1) When the function dial is in the LoZ ACV position, short press the Hz/INRUSH button to enter
the frequency measurement mode.
2) Short press the Hz/INRUSH button again to exit the frequency measurement mode.
34
jack, and black test lead into the COM jack.
or position.
jack, and black test lead into the COM jack.
Picture 3