Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY REPLACEMENT (PICTURE 8)
1) Turn off the meter and remove the test leads from the input jacks.
2) Unscrew and remove the battery cover.
3) Replace with 3 standard AAA batteries according to the polarity indication.
4) Secure the battery cover and tighten the screw.
TEST LEAD REPLACEMENT
If the insulation on the test lead is damaged, replace it.
Warning: Test leads used for MAINS measurement should meet EN 61010-031
standard, rated CAT III 1000V, 10A.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the machine
being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed
number.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones
must be collected and arranged separately. If you have to throw them out, please, do not use
the usual rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly
filled within one week after purchased the machine to the maker.
------
CORRECT USE
This tool should not be used for work for which it is not specifically designed.
RECYCLING
In order to respect and take care of the environment, it is necessary that all the pieces that
make up this tool are deposited in a specific container or green point for them.
40
Picture 8
NOTES
GUARANTEE
Publicidad
