Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
- Do not input voltage above 1000V. Although it is possible to measure higher voltage, it may
damage the meter.
- Be cautious to avoid electric shock when measuring high voltage.
- Test known voltage before use to verify whether the product functions correctly.
- After using the LoZ function, let the meter rest for 3 minutes before next use.
- LoZ voltage measurement eliminates ghost voltage for more accurate measurement.
- When the measured voltage is above 30V, the LCD will display the high voltage alarm prompt
"
".
RESISTANCE MEASUREMENT (PICTURE 4)
1) Insert the red test lead into the
2) Turn the function dial to the
resistance measurement if required, and to connect the test leads with both ends of the
measured resistance in parallel.
Note:
- If the measured resistor is open or the resistance exceeds the maximum range, the LCD will
display "OL".
- Before measuring the resistance online, switch off the power supply of the circuit, and fully
discharge all capacitors to ensure accurate measurement.
- When measuring low resistance, the test leads will produce 0.1Ω~0.2Ω measurement error.
Use "REL" measurement mode to get accurate readings.
- Short-circuit the test leads, and then short press the REL ZERO button.
- After the meter automatically subtracts the resistance of the short-circuited test leads, the
low-resistance measurement can be performed.
- If the resistance is not less than 0.5Ω when the test leads are short-circuited, please check
the test leads for abnormalities.
Picture 4
jack, and black test lead into the COM jack.
position, short press the SELECT button switch to
35
Publicidad
