Xylem SI Analytics AVS 470 Manual De Instrucciones página 55

Result n. corr.
Average = 234.56 s
SUS
Temperature = 100° F
Result n. corr.
Average = 234.56 s
SFS
Temperature = 250° F
Result n. corr.
Average corr. = 234.56 s
eta rel.
eta spec.
V.N.
Retrieve measurement values
Main menu
measurements [s]
meas. 1: 1234.67 *
main menu
press Enter
In the „Creation mode", you can at any time return
to the previous screen by pressing the "Esc" key
Create method
mode: absolut
Saybolt
relative
blank value
= 356
= 234
= 1.23456
= 0. 23456
= 234.56 [ml / g]
Fig. 10 Display of the measurement result
Example: Absolute measurement with
calculation of SUS (Sayboldt Universal seconds)
without Hagenbach-Couette correction
(exemplary!)
Fig. 11 Display of the measurement result
Example: Absolute measurement with
calculation of the SFS (Sayboldt Furol seconds)
without Hagenbach-Couette correction
(exemplary!).
Fig. 12 Display of the measurement result
Example: Relative measurement with
correction. This example shows the result of a
relative measurement with the application of the
Hagenbach-Couette correction.
The average shown represents the amount,
reduced by the correction seconds which are also
shown (exemplary!)
The VN (viscosity number) is determined using
the concentration which was input in Fig. 19.
As soon as you confirm the result with Enter, you
will be taken to the "Retrieve Measurements
values" mode.
Fig. 13 Retrieve measurement values
If the measurement mode was selected, you can
retrieve the individual measurement values one
by one at this point.
If this is not needed, you can return to the starting
screen (Fig. 4).
Fig. 14 Retrieve and scroll through
measurement result
Use the ↑ and ↓ key to retrieve the individual
measurement results.
The "*" sign means that this value was used in the
calculation.
To finish, press the "Enter" key to return to Fig. 4.
Fig. 15 Creation mode following Fig. 14
Selection from 4 modes: With the "Enter" key
If you select "absolute" and "relative", you will
proceed to Fig. 16.
Selecting "Saybolt" will take you to Fig. 18
Select "Blank value" to proceed to Fig. 21
55