AEG WS 650-115 Instrucciones De Uso página 5

Electronics
Speed selection
Mounting the
protective cap
Fitting the
working tool
FIXTEC quick-
action adjusting
nut
Adjusting nut
ENGLISH
The speed of rotation is adjusted electronically when the load increases.
Under the effect of extreme electromagnetic interferences from the outside, tempo-
rary variations in the speed of rotation could arise in particular cases.
Speed pre-selection with the setting wheel:
A= lowest speed
G= highest speed
Push the protective cap over the spindle as shown
in illustration.
Turn the protective cap until the tension spring
locks into place behind the fence. The protective
cap can be rotated between the two fences.
To remove the protective cap lift the tension
spring slightly with aid of a screwdriver and com-
pletely turn it. Pull the protective cap off the spin-
dle.
Always disconnect the plug from the socket before carrying out any work on the ma-
chine.
Lock the work spindle by depressing the spindle
lock. Mount the tension flange, the working tool,
and the adjusting nut as shown in illustration.
Only tighten and loosen the FIXTEC quick-action adjusting nut by hand. Do not use
any tools!
Insure that the hoop of the FIXTEC quick-action adjusting nut is only placed in the
upward position for tightening/loosening.
Loosen respectively tighten the djusting nut with a pin-type face spanner.
5 WS 650-115, WS 715-115, WS 715-125, WSE 800-125