Helo RONDO 96 Instrucciones De Uso E Instalación página 21

INSTALLATION OF HEATER STONES AND INSULATION RINGS
Before the installation of heater stones and insulation rings the heater has to be installed into its location and its electrical
connections secured. Moving of the heater while it is full of heater stones may damage the heater / floor.
- Remove the insulation rings before the loading of the heater stones.
- Lift the top insulation ring directly upwards.
- Loosen the allen screws (2 pcs, see arrows in figure 3) on the inside circumference of the
rotating ring so that the rotating ring can be lifted away. NOTE! Don't loosen the screws
entirely as they may fall inside the heater.
- Next lift the lower insulation ring from its location.
- Load the heater stones meant to be inside the heater as shown in the figure. The stones
must cover the resistors (see figure 1).
- First install the lower insulation ring in its place (see figure 2).
- The insulation ring must be set in its location and it must not be left to rest on the heater
stones.
- Next install the rotating ring with lids into its location (see figure 3).
- Turn the lid to the desired position before tightening the locking screws.
- NOTE! The lid, however, must not direct steam / hot air directly against the wall or some
other obstacle. Note the protection distances!
- Tighten the screws so that the rotating ring is not able to move. However, do not use
excessive strength while tightening. This may make the removal of the ring difficult, for
example in connection with maintenance.
- Check finally that the rotating ring stays in its place also when the lid is opened.
- Next install the control pads of the top insulation ring (3 pcs, see figure 4) in their place.
- The control pads have to be placed evenly on the circumference of the lower insulation stone.
- Finally install the upper insulation ring in its place as shown in the figure.
- Check also that the insulation rings are undamaged and in their place.
- NOTE! If the insulation ring or rings are cracked or are otherwise damaged, the heater must not be used until the
damaged insulation rings have been replaced!
Figure 3
RA 19 Controller Type 1601-19
OK
Figure 4
Sauna light control on / off
Stone space temperature display
Operational time display (full
power)
Sauna room temperature display
(requires installation of a sensor
as an accessory)
Simmering mode on
Addition of the setting rate
Saving the setting rates
Connection of full power
Selection of the operational mode
Reduction of the setting rate
Activation of the controller
Figure 1
Figure 2
Figure 5
Button functions:
While the controller is in standby mode (displays not lit)
the clicking of the button will activate the controller.
When the controller is active, pressing this button will
stop all functions and the controller / heater is
disconnected.
The button is used to accept any changes in the settings
and / or to move to the next setting / operational mode.
Increases the setting rate. Browsing of the rates can be
speeded up by holding the button pressed down.
Reduces the setting rate. Browsing of the rates can be
speeded up by holding the button pressed down.
Activates a relay on the circuit board. The heater has
its own connector for the lighting controller, voltage
230 VAC and the maximum power 100W. A led is
activated next to the
panel when the light/s is/are on.
light button on the Control
2