Helo RONDO 96 Instrucciones De Uso E Instalación página 23

Heater operation
The Rondo heater is a reserving heater as regards its function. This means that the heater has a thermo-insulated stone
space which maintains a certain basic heat with simmering mode which is smaller than the heater power. This enables
using sauna without long heating times thus differing from the normal heaters which are heated for one-off use. Due to its
large stone space the heater offers plenty of heat.
Setting the heater for simmering mode
The main switch disconnecting the electrical output to the heater is located in front of the heater in the lower edge. This
switch can be used to disconnect the heater from power if the heater is not used for a long period of time (for example
when leaving for a holiday). In normal use this switch should always be in the ON position.
The lid of the heater has to be closed when using the simmering mode.
When the power is connected using the control panel switch button, the upper led display starts flashing and indicates
the latest set simmering mode. The latest set temperature will always be stored in the memory. The temperature can be
set with the + and - buttons once the upper display is flashing. The setting range for the simmering mode is 150 - 250°C.
The change of the setting is stored in memory by pressing the OK button or alternatively by waiting for about 3 seconds
when the controller stores the change automatically. Then the heater connects the simmering mode on.
OK
=
Activate the The saved
controller simmering mode
temperature
flashes in the
upper display.
When the heater is on simmering mode, the lower led display indicates with dashed lines the simmering mode in relation
to the requested temperature. The upper display indicates the current temperature of the stone space. The required
simmering mode has been reached once all the three dashed lines are lit.
Stone space temperature
much cooler than the
set temperature
Setting of the heater on full power
When the heater is set on full power, the heater lid must always be opened!
Transfer from the simmering mode to full power is undertaken by holding down the control panel OK button for about 3
seconds. Then the controller moves to the full power setting mode and the flashing upper display shows the latest set
stone space maximum temperature. When the display is flashing the temperature of the stone space can be set to the
desired rate by using the + and – buttons. The setting range is 250°C – 300°C.
The change of the setting is stored in the memory by pressing the OK button or alternatively by waiting for about 3
seconds and then the controller stores the change automatically and moves to the next setting point.
If no change in the temperature is desired, the operation can be continued by pressing again the OK button or
alternatively by waiting for about 3 seconds and then the controller moves automatically to the next setting point.
OK
= =
The simmering Changed
mode temperatur simmering
can be changed mode
by using the + and Temperature
- buttons when the
display is flashing.
Stone space temperature
half-way of the set
temperature
OK
= =
Accept the The heater
change by goes to
pressing the simmering mode
OK button or
wait appr.
3 seconds.
Stone space temperature
achieved the set
temperature
4