Publicidad
Idiomas disponibles
Idiomas disponibles
Operational times and
control settings:
Thermostatically controlled simmering level
4.5 kW unit is approx. 500 W
6.5 kW unit is approx. 700 W
9.6 kW unit is approx. 1000W
Sauna's temperature display:
Detector OLET 19 obtainable as an accessory can be installed to a (free) wall, for example 300 - 500mm from the
ceiling. This sensor is only for the temperature display of the sauna room and therefore its location has no particularly
significant meaning. The temperature is shown in the lower display of the control panel alternating with the timing once
the full power has been connected on. The controller's electronics detect automatically the sensor once it has been
connected.
However, the sensor must not be installed above the heater nor in the corner as then the temperature display
may be distorted.
Control panel error displays:
When certain error conditions appear, the control panel is able to identify via its display what may cause the distortion.
When a distortion occurs, the displays will show an error notification and the alarm output in the heater is activated. This
output can be connected, for example to a buzzer (12V DC max 25 mA), creating also an audible alarm.
SEn Err (Sensor Error) stone space element disconnected or damaged.
SEr Err (Serial Error) serial traffic error between the heater and the controller.
hiL Err (High Limit Error) stone space overheated (>400°C), electronic disconnection.
CIRCUIT CARD OLEA 71
Control panel
Stone space
thermoelement
Sauna space
sensor element
(Optional extra)
Operational time (full power)
Stone space temperature (full power)
Stone space temperature (simmering mode)
Rus
+
-
Val
Rx
Vih
Kel
Tx
Val
- K
Vih
+K
Kel
T1
Pun
T2
L1
L2
U
V
0 – 2 hours
250 – 300°C
150 – 250°C
Alarm contact
Heater light
12 VDC 25 mA
LED
A1A2
L3
Control
Light
W
F2
L
3
Publicidad
