Publicidad
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
A(mm)
B(mm)
760
50 min.
20 min.
WARNING: Ensuring Adequate Ventilation
Make sure the induction cooker hob is well ventilated and
that air inlet and outlet are not blocked. In order to avoid
accidental touch with the overheating bottom of the hob,
or getting unexpectable electric shock during working, it
is necessary to put a wooden insert, fixed by screws, at a
minimum distance of 50 mm from the bottom of the hob.
Follow the requirements below.
6
wall
Min.30 mm
C(mm)
D
E
Air intake
Air exit 5 mm
EN
B
Using the appliance
WARNING:
• There are ventilation holes around outside of the hob. YOU
MUST ensure these holes are not blocked by the worktop
when you put the hob into position.
• Be aware that the glue that join the plastic or wooden
material to the furniture,has to resist to temperature not
below 150°C, to avoid the unstuck of thepaneling.
• The rear wall, adjacent and surrounding surfaces must
therefore be able towithstand an temperature of 90°C.
Before installing the hob, make sure that
• The work surface is square and level, and no structural members interfere with space
requirements.
• The work surface is made of a heat-resistant and insulated material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and applicable standards and
regulations.
• A suitable isolating switch providing full disconnection from the mains power supply is
incorporatedin the permanent wiring, mounted and positioned to comply with the local
wiring rules andregulations.
• The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation inall poles (or in all active [phase] conductors if the local wiring rules allow for
this variation of therequirements).
• The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation.
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfacessurrounding the hob.
After installing the hob, make sure that
• The power supply cable is not accessible through cupboard doors or drawers.
• There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection barrier is
installedbelow the base of the hob.
• The isolating switch is easily accessible by the customer.
7
EN
Publicidad
