Publicidad
Idiomas disponibles
Idiomas disponibles
10. Operation
The equipment is designed
for intermittent duty. Refer
to Section 6 for detail relating to the maximum run time of each
model, along with the necessary cooldown period.
10.1 Controller Error Codes
Fault LED Status
1 blink
2 blinks
3 blinks
30 Minutes Solid
11. Maintenance
Prior to any maintenance
activities, ensure the equipment is de-energised both electrically
and hydraulically.
The equipment does not require maintenance; however, the
following activity is recommended:
• Weekly: check hose connections are secure and filters aren't
blocked.
• Monthly: check the electrical connections and cables are in
good connection on a monthly basis.
• Ongoing: check pipework insulation to maintain efficiency and
reduce condensation.
The equipment is not designed to be disassembled for maintenance.
13. Spares and Replacements
Please contact your local distributor or customer services for
assistance.
13.1 23870
Description
Over/ Under Voltage
Over/ Under Current/ Run Dry
Over Temperature/ Over Runtime
Over Runtime (Cooling Down)
12. End of Life/
Disassembly
Prior to any decommissioning activity, ensure the equipment is
de-energised both electrically and hydraulically.
1. Allow the device to cool for a minimum of 15 minutes
following shut-down.
2. Disconnect pipework and remove power supply cable routing.
3. Remove all mounting screws / clips holding the mounting
plate to the mount point, and carefully lift the equipment out
of the mount point.
4. Dry the equipment and ensure it is clear and free of fluid prior
to storage / return / disposal.
Storage: Refer to Section 6 for requirements.
Return: Pack the equipment carefully and securely, ensuring it
is not free to move about during transport. Mark the package as
unsuitable for carrying load, unless specifically designed to do so -
load must not be applied to the equipment at any time.
Disposal: Equipment must be disposed of responsibly. EU
customers refer to Section 7 for disposal detail. Outside the EU,
contact your local authority for disposal requirements.
9
KEY
DESCRIPTION
1
SCREW M5X60
2
WASHER
3
COVER
4
ROTOR
5
VANE
6
O-RING
7
BODY
8
SEAL
9
O-RING
QTY
2
2
1
1
5
1
1
1
1
Publicidad
