Adjusting The Pool Water Temperature; Setting The Inversion Of The Current Powering The Cell; Boost Mode - Pool Technologie Poolsquad iPO Ampero 8 Instrucciones De Uso

Sensor
activated
Cover
External
command
Flow
Empty
container
Water temperature equal to or higher than 15°C
Temperature
Water temperature equal to or higher than 45°C
* Contact a professional to modify this value.

3.7.15. Adjusting the pool water temperature

If the temperature sensor is deactivated, the following menu will not appear.
Menu
From -5°C to + 5°C, compared to the value displayed, in

3.7.16. Setting the inversion of the current powering the cell

The aim of the current inversion is to prevent limescale being deposited on the cell. The inversion
frequency must be correctly set following the table below in order to ensure that the cell continues to operate
correctly over the long term.
Menu

3.7.17. Boost mode

The Boost mode:
- allows for meeting a need for chlorine.
- sets the production setpoint up to 100%, for a fixed period.
- can be stopped manually at any time.
Boost mode cannot substitute for a classic shock treatment in the event water is unsuitable for bathing.
It is impossible to start the Boost mode if:
- An alarm has been activated. (After having resolved and dismissed this alarm, wait a few moments in order to be
able to activate the Boost mode.)
- The operating mode of the electrolytic cell is set to "OFF".
If the Boost mode is restarted manually while it is already running, the Boost mode resets for the duration
displayed.
Boost mode continues after powering off the electronics unit.
Configuration
Open cover
Closed cover
Command activated
Command not activated
Sufficient flow
Zero flow
Empty container
Container not empty
Water temperature below 15°C
(Reactor OR Pool)
(Reactor OR Pool)
Possible settings
increments of 0.5°C
Possible settings
0, 12 or 24 hrs
Specific
Production
display
- Maintained
Divided by 5*
- Maintained
Stopped
- Maintained
Stopped
Maintained
- Maintained
Stopped
- Sustained
Stopped
Default setting
Current measurement
Default setting
pH regulation
Maintained
Stopped
Maintained
24 hrs
15