Publicidad
Idiomas disponibles
Idiomas disponibles
Practice / Spraying Technique
NOTE - Be sure that the paint hose is free of kinks and clear of objects with sharp cutting edges.
1. Switch the pump ON (l). Turn the PRIME/SPRAY knob to
SPRAY. Turn the pressure control dial to maximum
pressure (+). The spray hose should stiffen as paint
begins to flow through it.
The key to a good job is an even coating over the entire surface.
This is done by using even strokes.
Tip:
Keep the spray gun at right angles to the
surface. This means moving your entire
arm back and forth rather than just flexing
your wrist.
Tip:
Keep the spray gun perpendicular to the
surface, otherwise one end of the pattern
will be thicker than the other.
Tip:
Trigger gun after starting the stroke. Release
the trigger before ending the stroke. The
spray gun should be moving when the trigger
is pulled and released. Overlap each
stroke by about 30%. This will ensure an
even coating.
If you expect to be away from your sprayer for more than
one hour, follow the Short-Term Storage instructions
(page 18).
English
The motor will cycle on and off automatically as it needs
pressure.
The pressure control dial can be be adjusted up or down
to achieve the desired spray pattern.
SPRAY
Follow the TIPS, below.
10
2. When motor shuts off, unlock the spray gun and spray a
test area to check the spray pattern.
Good spray pattern
Paint tailing pattern
(pressure too low,
clogged tip)
Light Coat
Heavy Coat
Approximately
10 to 12 inches
Right way
Right way
Keep stroke
even
Start
Pull
Move
stroke
trigger
steadily
Light Coat
Wrong way
Approximately
10 to 12 inches
Release
End
trigger
stroke
Publicidad
