Publicidad
Idiomas disponibles
Idiomas disponibles
Do not plug in the sprayer until setup is complete.
Tools needed for assembly:
• Two adjustable wrenches
• 3/16" Allen wrench
If you have a cart model (PF30), follow these assembly instructions.
If you have the model PF23 sprayer, skip to item 4, below.
1. Insert the bolts through the holes in
the handle and cart and the locking
washers. Tighten the wing nuts
onto the bolts by hand.
4. Thread the high pressure hose to the spray hose port.
Tighten with an adjustable wrench.
6. Thread the suction
tube onto the inlet
valve and tighten
firmly by hand. Be
sure that the threads
are straight so that
the fitting turns freely.
English
Assembly
• Extension cord (refer to Important Electical
Information (page 3).
2. Insert the ends of the hose bracket
into the holes of the handle as
shown.
5. Thread the other end of the hose to the spray gun. Hold
the gun with one adjustable wrench, and tighten the hose
nut with the other.
The spray tip SHOULD NOT
be attached until after the
sprayer and spray hose have
been purged and primed.
7. Press the return
tube onto the
return tube fitting.
Squeeze clip
over the return
tube fitting to
secure the return
tube.
6
3. Attach the pail bracket. Line up the
holes in the bracket with the holes in
the sprayer. Insert and tighten the
screws using a 3/16" allen wrench.
8. Verify that the seal is
present inside the
suction tube. Thread
the inlet filter into the
end of the suction
tube.
Publicidad
