Publicidad
Idiomas disponibles
Idiomas disponibles
Purging and Priming the Spray Hose
1. Unlock the spray gun and turn the PRIME/SPRAY knob to
PRIME.
The spray tip SHOULD NOT
be attached to your spray
gun when purging your
spray hose.
Keep hands clear from fluid stream.
Ground the gun by holding it against the edge of a metal container while flushing. Failure to do so may lead
to a static electric discharge which may cause a fire.
3. While pulling the trigger, switch the pump ON (l), AND
turn the PRIME/SPRAY knob to SPRAY. Hold the
trigger until all air, water, or solvent is purged
from the spray hose and material is flowing freely.
If the PRIME/SPRAY knob is still on SPRAY,
there will be high pressure in the hose and
spray gun until the PRIME/SPRAY knob is
turned to PRIME.
4. Release trigger. Turn the PRIME/SPRAY knob to PRIME.
Turn the pump OFF (O). Trigger the gun into the waste
container to be sure that no pressure is left in the hose.
2. PULL the trigger and aim the spray gun at the side wall of
a waste container. If using oil-based materials, the
spray gun must be grounded while purging (see
warning below).
SPRAY
5. Lock the spray gun off. Thread the spray tip guard
assembly onto the gun. Tighten by hand.
Begin
tightening
the tip at
this angle
9
. . .to achieve
the desired
spray angle
when tight.
English
Publicidad
