Publicidad
Idiomas disponibles
Idiomas disponibles
Routine Maintenance
EN
Clean the Sensors
Wipe sensors and charging contacts by using a soft and dry cloth, as shown in the diagram.
Note: Wet cloths can damage sensitive elements within the robot and charging dock. Please use dry rags for cleaning.
Point Laser Sensor
Edge Sensor
Return-to-Dock Sensor
Cliff Sensor
Charging Contact
Charging Contact
Cliff Sensor
Cliff Sensor
R
L
R
L
OFF ON
Charging Contacts
18
Collision Detection Sensor and Bumper
Infrared Deceleration Sensor
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold down
the button
for 10 seconds or press the ON/OFF rocker switch to forcefully
turn it off. Then press and hold the button
for 3 seconds to turn the robot
on.
Battery
The robot contains a high-performance lithium-ion battery pack. Please
ensure that it remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of
time, turn it off and put it away. To prevent damage from over-discharging,
the robot should be recharged at least once every three months.
Troubleshooting
Problem
The battery level is low. Recharge the robot on the charging dock, then try again.
Robot does not turn on
The temperature of the battery is too low or too high. It is recommended to operate the appliance at a temperature
between 32 ℉ (0°C) and 104 ℉ (40°C).
The charging dock is not receiving power. Please confirm that both ends of the charger are plugged in correctly.
Robot does not recharge
Poor contact. Clean charging contacts of the charging dock and robot.
There are too many obstructions around the charging dock. Place the charging dock in a more open area.
Robot does not return to
charging dock
Please clean the dock's signaling area.
Robot is malfunctioning
Turn off the robot and then reactivate it.
A foreign object may be caught in the main brush, side brush, or one of the main wheels. Stop the robot and remove
Robot is making a strange noise
any debris.
The dust box is full. Please clean it.
Robot no longer cleans
The filter is blocked. Please clean it.
efficiently or leaves dust behind
A foreign object is caught in the main brush. Please clean it.
Solution
19
EN
Publicidad
