Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use
EN
1. Rocker Switch
Press the ON/OFF rocker switch on the bottom to activate the robot.
2. Turn On/Off
Press and hold the button
for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the charging dock, the
robot should turn on automatically and begin charging. To turn off the robot,
move the robot away from the dock and press and hold the
button for 3
seconds.
3. Fast Mapping
After configuring the network for the first time, follow the instructions on
the app to quickly create a map, and the robot will start mapping without
cleaning. The mapping process will be completed when the robot returns to
the dock, and the map will be saved automatically.
4. Start Cleaning
Press the button
briefly to start cleaning after the robot is turned on.
Then, the robot will accurately map out a route, methodically clean along
the edges and walls, then finish by cleaning each room in an S-shaped
pattern to ensure a thorough job.
Note: If vacuum only, please remove the mop pad holder.
12
5. Cleaning Mode
The robot has four cleaning modes: Quiet, Standard, Strong, and Turbo.
The default mode is Standard. You can specify the cleaning mode in the
app.
6. Pause/Sleep Mode
When the robot is running, press any button to pause it. If the robot is
paused for more than 10 minutes, it automatically enters sleep mode. All
indicators on the robot will turn off. Press any button on the robot, or use
the app to wake up the robot.
Note: If the robot is paused and placed onto the charging dock, the current
cleaning task will end.
7. Spot Cleaning
When the robot is paused or in Standby Mode, press and hold the button
for 3 seconds to start Spot Cleaning Mode. In this mode, it will clean a square-
shaped area of 1.5×1.5 meters directly around the robot. When the spot
cleaning is done, the robot will automatically return to its original location and
stop working.
Note: Activating Spot Clean Mode will end the current cleaning task of the robot.
8. Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator goes out. The DND
mode is disabled by default at the factory. You can use the app to enable the
DND mode or modify the DND period. The DND period is 22:00-8:00 by default.
Note:
· The scheduled cleaning tasks will be performed on time during the DND period.
· The robot will resume cleanup where it left off after the DND period expires.
How to Use
9. Scheduled Cleaning
You can schedule cleaning time in the Dreamehome app. The robot will
automatically start cleaning at the designated time and then return to the
charging dock to recharge when the cleaning is done.
10. Additional App Functions
Follow the instructions on the app interface to use more functions. The version
of the app might have been updated; please follow the instructions based on
the current app version.
11. Use the Mopping Function
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
1) Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
②
①
③
2) Fill the tank with water.
Note:
· It is recommended to remove the dust box before filling the tank with water, to
avoid dampening the dust box.
· Do not use detergent or disinfectant.
3) Slide the 2-in-1 water tank with dust box and mop assembly into the
back of the robot until it clicks into place. Press the button
or use the
Dreamehome app to start cleaning.
Click
Click
Note:
· It is not recommended to use the mopping function on carpets.
· Use the app to adjust the water flow as required.
EN
13
Publicidad
