Champion Global Power Equipment 100304 Manual Del Operador página 32

100304 - 22-kW HOME STANDBY GENERATOR WITH AXIS CONTROLLER
5. Press and hold AUTO button for approximately 5 seconds or
until you see hour meter reset to 100. Release button.
6. You have now reset the maintenance hour meter to 100 hours
and can press OFF to exit.
7. Press AUTO once and the system goes in standby mode.
®
Corrosion Protection
Never use a pressure washer to wash the interior of the
generator with water.
Wash the outside of the enclosure using a mild soap and water.
Use an automotive-type wax and wax the outside of the enclosure
to protect it from the elements. If used in a salt water/coastal
area, the enclosure should be washed more frequently to prevent
corrosion. Spray light oil on the hinges for the enclosure doors.
Maintenance After Submersion
Never try to start or operate the generator if it has been
submerged underwater or exposed to a flood.
If the generator has been in conditions where it became
submerged underwater, the generator must be inspected and
maintenance must be performed before returning the generator to
service.
Turn engine control module and ATS control module to the OFF
position. Have a authorized Champion Dealer inspect the generator
and perform any necessary maintenance.
If the house or building has been exposed to a flood, it should be
inspected by a certified electrician for any electrical problems
that may occur if the generator is put back into service or if utility
power is restored.
Storage
If the generator is not going to be used for several months and not
exercised every 7 days, it should be prepared for storage.
1. Manually start the engine and run it for several minutes to
allow it to warm up.
2. With the engine running, turn the fuel shutoff valve to the
closed position and let the engine continue to run until it
shuts down.
3. Once the engine has shut down, press the OFF button on the
aXis Controller . Put the generator ON/OFF switch to the OFF
®
position.
4. Switch the generator's main circuit breaker to the OFF (OPEN)
position.
5. Turn off the utility power to the transfer switch.
6. Disconnect the battery cables. Remove the negative cable
first.
7. Change the engine oil. See Changing the Engine Oil on page
26.
32
MAINTENANCE
NOTICE

WARNING
