Publicidad
Idiomas disponibles
Idiomas disponibles
1
INSTALL TRANSFER VALVE
Turn off hot and cold watert
CAUTION
supplies before beginning.
• Apply sealant or Teflon tape to threads of SPRAY ELL (1) and install into TRANSFER
VALVE (2). Note: Arrow on SPRAY ELL (1) points down, see illustration.
• Install "Y" HOSE ADAPTER (3) with SEAL (4) to bottom nipple of
TRANSFER VALVE (2) and tighten to make a water tight seal.
• Install LOWER CONE SEAL (5) onto TRANSFER VALVE (2) and
insert TRANSFER VALVE (2) from under side of Bidet into the
center forward hole.
• Install UPPER CONE SEAL (6), FRICTION WASHER (7) and
MOUNTING NUT (8) onto TRANSFER VALVE (2).
• Tighten MOUNTING NUT (8) to secure the TRANSFER VALVE (2)
and make a water tight seal.
• Thread TRANSFER VALVE ESCUTCHEON (9) onto MOUNTING
NUT (8). until snug against bidet ledge.
INSTALL CONTROL VALVES
• Unpack valve assembly and remove HANDLE (10) by unthreading
SET SCREW (11). Unthread ROSETTE (12) and FLANGE (13)
removing them from VALVE BODY (14).
• Thread LOCKNUT (15) to bottom of VALVE BODY (14). Make sure
SPACER (16), BRASS WASHER (17) and RUBBER WASHER (18)
are installed.
• Insert VALVE BODY (14) through mounting hole from underside
of bidet ledge.
Note: VALVE BODY marked Hot is installed in the left Mtg. hole,
VALVE BODY marked Cold in the right when facing front
of fitting.
• Install STOP RING (19) onto VALVE BODY (14) if not in place.
Install O-RING (20) into groove in FLANGE (13).
• Thread FLANGE (13) flush against STOP RING (19). Thread
ROSETTE (12) onto VALVE BODY (14) until tight against it's internal stop.
• Align VALVE BODY (14) as shown and from below tighten LOCKNUT (15)
to secure VALVE BODY (14).
2
INSTALL HANDLES
• Turn VALVES to off position. Align HANDLES (1) as shown or
as desired and install onto HANDLE ADAPTER (2). Tighten SET
SCREW (3) with HEX WRENCH (4) supplied. Push PLUG
BUTTON (5) into place.
11
12
GROOVE
13
19
BIDET
LEDGE
18
17
16
15
14
HOT
APPLY TEFLON
1
- 2 -
9
20
8
10
7
6
5
FRONT
10˚
10˚
2
COLD
1
4
TAPE
3
3
2
1-1/2"
(38 mm) MAX.
M965497 Rev. 1.8 (3/23)
4
5
Publicidad
