Publicidad
Idiomas disponibles
Idiomas disponibles
3
POP-UP DRAIN
• Remove CLEAR PLASTIC COVER (1).
• Remove CARDBOARD SPACER (2) from under
DRAIN POP-UP (3).
• Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
4
REMOVE FLANGE
• Thread FLANGE (1) counter-clockwise and remove
FLANGE (1) and FOAM GASKET (2) from drain
body. Fig. A.
• Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B.
5
INSTALL DRAIN FROM
BELOW FIXTURE
• From under side of BIDET
install DRAIN BODY (1) up
through drain outlet.
Note: No plumber's putty
or caulk is required.
The CABLE ATTACHMENT
POINT (2) must face towards
the rear of the BIDET.
• Install FOAM GASKET (3) and
FLANGE (4) onto drain body
from above BIDET and
tighten FLANGE (4) firmly.
7
FLANGE GASKET
• Check DRAIN FLANGE in BIDET to ensure that WHITE
FOAM GASKET (1) is fully compressed and not visible.
Fig. A.
POP-UP ASSEMBLY
• Insert LIFT ROD GUIDE (1) and CABLE CONNECTOR (2)
through rear hole, making sure SEAL WASHER (3) is
properly seated. Fig. B.
• From below slip slot in MOUNTING NUT (4) over CABLE (5).
Thread NUT (4) onto lift rod guide shank to secure ROD
GUIDE (1) to bidet. Hand tighten only. Fig. B.
4
3
DRAIN
OUTLET
1
2
Fig. A.
DRAIN
FLANGE
- 3 -
Fig. A.
1
3
2
Fig. A.
1
2
6
TIGHTEN LOCKNUT
• Tighten LOCKNUT (1) firmly with
Adjustable Wrench or Channel Locks.
Fig. B.
Fig. B.
1
WHITE FOAM
ILLUSTRATION
GASKET
SHOWN LESS
NOT VISIBLE
VALVES
Fig. B.
DRAIN
BODY
4
Fig. B.
4
3
1
1
3
5
SLOTTED
MOUNTING
NUT
4
2
M965497 Rev. 1.8 (3/23)
Publicidad
