Publicidad
Idiomas disponibles
Idiomas disponibles
8
ATTACH CABLE
CONNECTOR
• POP-UP KNOB (1) must be fully
down. Fig. A.
• Thread CABLE CONNECTOR (1)
clockwise onto DRAIN BODY
CONNECTION (2) and hand
tighten. Fig. B.
Your new POP-UP DRAIN
installation is now complete.
Fig. C.
Note: Tailpeice on pop-up drain
is 1-1/4" O.D. Fig. C.
9
CHECK OPERATION OF POP-UP
• Operate LIFT KNOB (1) to verify that STOPPER (2)
opens and closes. Fig. A.
Note: If STOPPER (2) does not open and close
properly then refer to the "troubleshooting
section" of theseinstructions.
INSTALL DIVERTER HANDLE
• DIVERTER HANDLE (1) onto VALVE STEM (2)
of DIVERTER. Fig. B.
• Secure with DIVERTER HANDLE SCREW (3).
• Thread HANDLE CAP (4) onto DIVERTER HANDLE (1).
10
INSTALL SUPPLY HOSES
Connect small end of SUPPLY HOSES (1) TO "Y"
ADAPTER (2) and larger end to each VALVE OUTLET.
Important: Loop SUPPLY HOSES (1) as illustrated
so they do not kink.
INSTALL SPRAY BODY
• Apply putty to the underside of SPRAY BODY FLANGE (3)
and install SPRAY BODY (3) into spray hole of Bidet.
• From underside of Bidet install RUBBER WASHER (4),
FIBER WASHER (5) and LOCKNUT (6) onto shank of
SPRAY BODY (3). Tighten LOCKNUT (6) to make water
tight seal.
• Connect one end of SPRAY HOSE (7) to HOSE ADAPTER (8)
and the other end to shank of SPRAY BODY (3).
Tighten hose connections to make a water tight seal.
WATER SUPPLY CONNECTION
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS
NOT INCLUDED AND MUST BE PURCHASED SEPARATELY.
• Connect water supply to VALVE BODIES (9,9a) with 1/2" IPS FLEXIBLE
SUPPLIES (10) or 3/8" O.D. BULL-NOSE RISERS (11). Use adjustable
wrench to tighten connections. Do not over tighten. Be careful not to
kink copper supply when bending. Use tubing cutter to cut to proper length.
• | Connect HOT water supply to inlet of left SHANK and COLD water supply to right
SHANK using sealant, appropriate connectors, and COUPLING NUTS.
• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to waste outlet.
Fig. A.
DOWN
Fig. A.
2
PUTTY
- 4 -
Fig. B.
2
LARGE
END
HOT
9
VALVE
3
OUTLET
FRONT
SMALL
END
4
COUPLING NUT
5
11
6
3/8 O.D.
BULL-NOSE
RISERS
7
COMPRESSION
NUT
FERRULE
CONNECT TO
WASTE OUTLET
Fig. C.
1
1-1/4" O.D.
Fig. B.
1
1
8
2
VALVE
7
OUTLET
1
LARGE
END
9a
COLD
1/2" PIPE
THREAD
10
FLEXIBLE
SUPPLIES
3/8 COMPRESSION
CONNECTION
M965497 Rev. 1.8 (3/23)
4
3
1
2
Publicidad
