Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
WARNING
Follow the safety instructions and the
notes regarding charging and correct use,
as specified in the operating manual for
your 20V gomag series battery and battery
charger. A detailed description of the
charging process and further information
are provided in this separate manual.
6
Technical data
Cordless hedge trimmer
Motor voltage:
Type of motor:
Weight (without battery and tool
attachment):
Hedge trimmer cutting data:
Cutting length:
Cutting diameter:
Angle adjustment:
Cutting speed:
Overall length:
Weight (drive and tool attach-
ment, without battery):
Pole-mounted pruner cutting
data:
Guide rail length
Cutting length:
Cutting speed:
Guide rail type:
Saw chain pitch:
Saw chain type:
Drive link thickness:
Oil tank content:
Angle adjustment:
Overall length:
Weight (drive and tool attach-
ment, without battery):
Subject to technical changes!
GO-HHS410
20 V
Brush motor
1.1 kg
410 mm
16 mm
11 steps (90° - 240°)
rpm
1200
2.6 m
2.95 kg
8"
180 mm
4.5 m/s
AP08-33-507P
3/8" / 9.525 mm
3/8.050x33DL
0.05" / 1.27 mm
100 ml
4 steps (135° - 180°)
2.35 m
3.0 kg
www.scheppach.com
Noise and vibration
WARNING
Noise can have serious effects on your health. If the
machine noise exceeds 85 dB, please wear suitable
hearing protection for you and persons in the vicinity.
The noise and vibration values have been determined
in accordance with EN 62841-1/EN ISO 3744:2010.
Noise data
Hedge trimmer:
Hedge trimmer sound pressure L
Sound power L
wA
Measurement uncertainty K
Pole-mounted pruner:
Pole-mounted pruner sound pressure L
Sound power L
wA
Measurement uncertainty K
Vibration parameters
Hedge trimmer:
Vibration a
front handle
h
Vibration a
rear handle
h
Measurement uncertainty K
Pole-mounted pruner:
Vibration a
front handle
h
Vibration a
rear handle
h
Measurement uncertainty K
The total vibration emission values specified and the
device emissions values specified have been measured
in accordance with a standardised test procedure and
can be used for comparison of one electric tool with an-
other.
The total noise emission values specified and the total
vibration emission values specified can also be used for
an initial estimation of the load.
WARNING
The noise emission values and vibration
emission value can vary from the specified
values during the actual use of the power
tool, depending on the type and the manner
in which the electric tool is used, and in
particular the type of workpiece being pro-
cessed.
Try to keep the stress as low as possible. For exam-
ple: Limit working time. In doing so, all parts of the
operating cycle must be taken into account (such as
times in which the power tool is switched off or times
in which it is switched on, but is not running under a
load).
77.9 dB
pA
89.0 dB
3 dB
pA
77.8 dB
pA
87.8 dB
3 dB
wA
3.04 m/s
2.48 m/s
1.5 m/s
2.55 m/s
2.48 m/s
1.5 m/s
GB | 35
2
2
2
2
2
2
Publicidad
