Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
DANGER
Danger of injury!
If the product is jammed, do not try to pull the product
out by using force.
–
Switch off the engine.
–
Use a lever arm or wedge to get the product free.
CAUTION
After switching off, the product will run on. Wait until
the product has come to a complete stop.
10.1
Switching the product on/off and
operating it (Fig. 1)
WARNING
Danger of injury due to kickback!
–
Never use the product one-handed!
Notes:
The speed can be steplessly controlled by the on/off
switch. The further you press the on/off switch, the
higher the speed.
Before switching on, make sure that the product does
not touch any objects.
When using the hedge trimmer (11):
1. Pull the blade guard (13) off the cutter bar (12).
When using the pole-mounted pruner (14):
1. Check that there is saw chain oil in the oil tank (15).
2. Fill in saw chain oil before the oil tank (15) is empty,
as described under Topping up saw chain oil (Fig.
7).
3. Pull the blade and chain guard (19) off the chainsaw
guide bar (13).
Switching on
1. Hold the front handle (8) with your left hand and the
rear handle (1) with your right hand. Thumb and fin-
gers must firmly grasp the grips (1/8).
2. Bring your body and arms into a position in which
you can absorb the kickback forces.
3. Press the switch-on lock (3) on the rear grip (1) with
your thumb.
4. Press and hold the switch lock (3).
5. To switch on the product, push the on/off switch (2).
6. Release the switch lock (3).
Note:
It is not necessary to keep the switch lock pressed after
starting the product. The switch lock is intended to pre-
vent accidental starting of the product.
Switching off
1. To switch it off, simply release the on/off switch (2).
2. Put on the supplied guide bar and chain guard (19)
or the cutter bar guard (13) after each instance of
working with the product.
10.2
Overload protection
In the event of overloading, the battery will switch itself
off. After a cool-down period (time varies), the product
can be switched back on again.
11 Working instructions
DANGER
Danger of injury!
This section examines the basic working technique
for using the product.
The information provided here does not replace the
many years of training and experience of a specialist.
Avoid any work that you are not adequately qualified
for!
Careless use of the product can lead to serious inju-
ries and even death!
CAUTION
After switching off, the product will run on. Wait until
the product has come to a complete stop.
Notes:
Before switching on, make sure that the product does
not touch any objects.
Some noise pollution from this product is unavoidable.
Postpone noisy work to approved and designated
times. If necessary, adhere to rest periods.
Only process free, flat surfaces with the tool attach-
ment.
Carefully inspect the area to be cut and remove all for-
eign objects.
Avoid bumping into stones, metal or other obstacles.
The tool attachment could be damaged and there is a
risk of kickback.
• Wear prescribed protective equipment.
• Ensure that other people remain at a safe dis-
tance from your workspace. Anyone who enters
the workspace must wear personal protective
equipment. Fragments of the workpiece or broken
accessory tools can fly off and cause injury – even
outside the immediate working area.
www.scheppach.com
GB | 39
Publicidad
