Publicidad
Idiomas disponibles
Idiomas disponibles
6. To check the product lubrication, hold the chainsaw
with the saw chain over a sheet of paper and give it
full throttle for a few seconds. You can see on the
paper whether the chain lubrication is working.
9.2
Fitting the tool attachment (11/14)
onto the telescopic tube (7) (Fig.
1)
1. Attach the desired tool attachment (11/14) to the
telescopic tube (7), paying attention to the position
of the tongue and groove.
2. The tool attachment (11/14) is secured by tightening
the locking nut (5).
9.3
Adjusting the telescopic handle
height (Fig. 1)
The telescopic tube (7) can be infinitely adjusted using
the locking mechanism (6).
1. Loosen the lock (6) on the telescopic tube (7).
2. Change the telescopic tube length by pushing or
pulling.
3. Tighten the lock (6) again to fix the desired working
length of the telescopic tube (7).
9.4
Adjusting the cutting angle (Fig.
12)
You can also work in inaccessible areas by changing
the cutting angle.
1. Press the two locking buttons (10) on the hedge
trimmer tool attachment (11) or the pole-mounted
pruner tool attachment (14).
2. Adjust the inclination of the motor housing in the
locking steps.
The locking steps integrated in the motor housing
secure the tool attachment (11/14) and prevent it
shifting unintentionally.
Hedge trimmer (11):
Cutting angle positions 1 – 11
Pole-mounted pruner (14):
Cutting angle positions 1 – 4
9.5
Fitting the shoulder strap (20)
(Fig. 8, 9)
WARNING
Danger of injury!
Always wear a shoulder strap when working. Always
switch the product off before loosening the shoulder
strap.
1. Clip the shoulder strap (20) into the carrying eye
(9).
2. Place the shoulder strap (20) over the shoulder.
38 | GB
3. Adjust the belt length such that the carrying eye (9)
is at hip height.
9.6
Inserting/removing the battery
(27) in the battery mount (4) (Fig.
10, 11)
CAUTION
Danger of injury!
Do not insert the battery until the battery-powered
tool is ready for use.
Inserting the battery
1. Push the battery (27) into the battery mount (4). The
battery (27) clicks into place audibly.
Removing the battery
1. Press the unlocking button (26) of the battery (27)
and remove the battery (27) from the battery mount
(4).
10 Operation
ATTENTION
Always make sure the product is fully assembled
before commissioning!
WARNING
Danger of injury!
The on/off switch and the safety switch must not be
locked!
–
Do not work with the product if the switches are
damaged. The on/off switch and the safety switch
must switch off the product when released.
–
Make sure the product is in working order before
each use.
WARNING
Electric shock and damage to the product
possible!
Contact with a live cable during cutting can result in
electric shock. Cutting into foreign objects can cause
damage to the cutter bar.
–
Scan hedges and bushes for hidden objects, such
as live wires, wire fences and plant supports, be-
fore cutting
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
www.scheppach.com
Publicidad
