Publicidad
Idiomas disponibles
Idiomas disponibles
Sawing off small branches (Fig. 14):
Place the contact surface of the saw against the branch
to avoid jerky movements of the saw when starting the
cut. Guide the saw through the branch with light pres-
sure from top to bottom, taking care not to break
through the branch prematurely if you have misjudged
its size and weight.
Saw off in sections (Fig. 15):
Saw off large or long branches in sections so that you
have control over where they land.
• Saw off the lower branches on the tree first to make
it easier for the upper branches to fall down.
• Once the cut has been completed, the weight of the
saw increases abruptly for the operator as the saw
is no longer supported on the branch. There is a
risk of losing control of the product.
• Only pull the saw out of the cut with the saw chain
running to avoid jamming.
• Do not saw with the tip of the tool.
• Do not saw into the bulging branch base, as this will
prevent the tree from healing.
11.3
After use
• Always switch the product off before placing it
down and wait until the product has come to a
standstill.
• Remove the battery.
• Put on the supplied guide bar and chain guard or
the cutter bar guard after each instance of working
with the product.
• Allow the product to cool.
12 Cleaning
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always perform
maintenance and cleaning work with the
battery removed. There is a danger of inju-
ry! Let the Product cool down before all
maintenance and cleaning tasks. Elements
of the engine are hot. There is a danger of
injury and burning!
The product can start unexpectedly and cause inju-
ries.
–
Remove the battery.
–
Allow the product to cool down.
–
Remove the tool attachment.
WARNING
Danger of injury when handling the saw
chain or the blade!
–
Wear cut-resistant gloves.
1. Wait until all moving parts have come to a standstill.
2. We recommend that you clean the product directly
after every use.
3. Keep handles and grasping surfaces dry, clean and
free from oil and grease. Slippery handles and
grasping surfaces do not allow for safe handling
and control of the tool in unexpected situations.
4. If necessary, clean the handles with a damp cloth
washed in soapy water.
5. Never immerse the product in water or other liquids
for cleaning.
6. Do not splash the product with water.
7. Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure. We recommend
that you clean the product directly after every use.
8. Ventilation openings must always be free.
9. Do not use any cleaning products or solvents; they
could attack the plastic parts of the product. Make
sure that no water can penetrate the product interi-
or.
12.1
Hedge trimmer
1. Clean the cutter bar with an oily cloth after each
use.
2. Oil the cutter bar after each use with the oil can or a
spray.
12.2
Pole-mounted pruner
1. Use a brush or hand brush to clean the saw chain
and no liquids.
2. Clean the groove of the chainsaw guide bar using a
brush or compressed air.
3. Clean the chain sprocket.
www.scheppach.com
GB | 41
Publicidad
