Publicidad
Idiomas disponibles
Idiomas disponibles
... Channel menu
Channel
Auto Scan
Channel Edit
Advanced Settings
AUTO SCAN
This is where you can start a new channel search. The pro-
cedure is the same as described in the section "Setting up
TV reception" on page 13.
CHANNEL EDIT
In the channel management menu there are various op-
tions for editing channel lists.
– ANTENNA / CABLE / SATELLITE
You can edit the currently selected channel list here.
– FAV
You can create four different favourite lists. To
do this, select the desired list and press O K .
Using the SENDER HINZUFÜGEN function,
you can now assign the desired channels from
the current channel list to the corresponding
favourites list. The filter and search function
(yellow button FILTER / blue button SUCHE)
makes it easier for you to search for channels.
– EXPORT TO USB
Select this option and press O K if you want to
save the current channel list externally onto a
USB drive, so that you can download it to an-
other device, for example.
– IMPORT FROM USB
Select this option and press O K if you want to
play a channel list from an external USB drive
on the TV.
ADVANCED SETTINGS
– MANUAL SCAN
This option is used for the direct entry of chan-
nel or satellite transponder data or similar.
DTV MANUAL SCAN
Enter all the necessary data here to search for
digital channels of the corresponding recep-
tion type here.
ATV MANUAL SCAN
Enter all the necessary data here to search for
analogue channels.
– CHANNEL LIST AUTO UPDATE
Activate this function if you want the channel
list to be updated automatically as soon as the
broadcaster makes changes.
– PROGRAMME GUIDE AUTO UPDATE
Select this option and press O K . Now activate
the PROGRAMME AUTO UPDATE option
if programme data of the programme guide
(EPG) is to be updated overnight in standby
mode. You can use the CHANNEL SELEC
TION option to specify which channels should
have their programme data updated.
– CI+ MODULE SETTINGS
If you want to watch subscription channels,
you must first register with the channel provi-
der. Once you have registered, you will receive
a Conditional Access Module (CA module) and
a special card from your provider. You will find
information about the settings in the docu-
mentation supplied with the module.
Install the CI components on your television in
the following way:
Switch the television off and pull out the mains plug.
First insert the CI module in the slot on the side of the
Smart TV. Then insert the card.
.
Please note: only insert or remove the CI mod-
ule after you have disconnected the device
from the power supply.
NOTICE!
Risk of damage!
The CI module or the television could
be damaged if you attempt to insert
the CI module by force.
The CI module must be inserted
correctly: it cannot be inserted if it
is the wrong way round.
Connect the television to the power
supply, switch it on, and wait for
a moment until the card is recog-
nised.
The options COMMON INTERFACE,
CI CARD AND PIN and CAM PROFILE
SEARCH can be edited in this menu. The con-
tent and the possible uses, however, depend
on the CI module used.
If no module is inserted, the message NO
CAM DETECTED appears on the screen.
.
The appearance and operation of the menu
may vary depending on the module used.
EN
27
Publicidad
