Publicidad
Idiomas disponibles
Idiomas disponibles
in a lying position. They should be re-tightened after each change
of position.
3.3.5
Making longitudinal cuts
•
Always use the parallel guide when making such cuts.
After turning on the machine and waiting for the cutting blade to
•
reach its working speed, place the element to be cut on the
worktop and then slowly push it by hand along the parallel guide
towards the blade, but not further than into the blade guard.
Use the attached pusher or - especially for small parts - a special
•
handle to cut the remains of the element (see the picture below):
Always push the workpiece to the cut is done, i.e. when it is fully
•
cut.
•
To cut larger elements, you can use the extension of the worktop.
EN
Publicidad
