Publicidad
Idiomas disponibles
Idiomas disponibles
3.4. Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
b)
Only cleaners that do not contain corrosive substances should be used to clean
plastic parts.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft cloth for cleaning.
j)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
3.4.1 Replacing the cutting disc
NOTE: when removing the cutting disc, it is recommended to use
protective gloves for the blade.
•
Remove the entire blade guard, i.e. cover and cover insert fastened to the
worktop:
Use the blade height adjustment lever to raise the blade as far as it will go.
•
EN
Publicidad
