Descargar Imprimir esta página

Zummo Viva Manual De Servicio página 23

Ocultar thumbs Ver también para Viva:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
5.4. IOT
The machine features IOT which is capable of providing real data
about your juicer.
Access machine configuration, statistics and errors via Apple Store
or Google Play.
You can also access by scanning the QR code.
5.5. CLEANING
The squeezing zone should be cleaned every day.
·
When the machine is stopped, switch off the power switch
[Fig. 19]. Then disconnect it from the power supply.
·
Unscrew the securing handle and remove the hopper track
[Fig. 1]. Remove the front cover and upper lid [Fig. 2], and then
clean them with a cloth moistened in a neutral soapy solution.
WARNING! NEVER clean these parts with abrasive products.
·
Pull the juicing block out horizontally [Fig. 3]. BE VERY CARE-
FUL WITH THE BLADE, it is extremely sharp and you may cut
yourself. To remove the juicing block, firstly remove the blade
and cups by holding the blade handles and pulling upwards
[Fig. 4]. Then remove the cups. To do so, we advise lifting the
cup slightly over the stops and then turning it through 45
while gently pulling outwards [Fig. 5]. We recommend fitting
the blade protector after cleaning the blade. This will allow
you to safely carry out the other cleaning operations [Fig. 6].
Next remove the balls by holding and pressing the handles
and then pulling upwards. Use both hands to ensure they are
removed correctly [Fig. 7]. Finally, remove the filter tray by
pulling it outwards horizontally [Fig. 8]. To remove the filter
shaft, pull it upwards [Fig. 9]. You can clean these compo-
nents in the dishwasher at the maximum temperature of 70
or you can wash them by hand.
·
Wash the bin and drip grill.
·
Clean the front of the machine, the upper lid and the feeder
paddle with the same soapy water solution.
Note: In the event of inappropriate cleaning, the guarantee will be
rendered void.
ASSEMBLY
After cleaning everything, assemble it in the following order:
1
Fit the filter shaft to the filter tray, you will notice a slight click
when it fits into place [Fig. 10]. Next fit the squeezing tray as-
sembly by introducing it in the slots on the squeezing tray [Fig.
11]. You should notice a slight click when it fits into place. This
means that it has been fitted properly.
2
Introduce the balls in the squeezing tray. Check that they are
fitted properly [Fig. 12].
3
Fit the cups to the blade making sure they are properly po-
sitioned [Fig. 13]. Then fit the assembly in the squeezing tray
and fit the slides in the ball slots [Fig. 14]. Remove the blade
protector. Be careful not to cut yourself!
4
Fit the juicing block in the machine, making sure it reaches the
o
back [Fig. 15].
C,
o
Service Manual
23

Publicidad

loading