DR-HO’S circulation promoter Manual De Instrucciones página 8

14
Problem Possible causes
The skin has turned red and/or You are allergic to the elec-
itches or prickles. trodes.
You have a small cut or acne.
The adhesive surface of the
pads is dirty or too dry.
The therapy has gone on too
long.
The 2 pads are not attached
firmly and fully to the skin.
The surface of the pads is
worn out.
Three yellow lights on the Pain One of the pads has become
Therapy Device are flashing disconnected from your skin or
and you cannot feel any a wire is unplugged.
stimulation.
Three green lights are flashing The auto shutdown timer has
and you cannot feel any activated and the device has
stimulation. powered of.
Batteries have been installed The battery compartment is
but the light does not turn on. dirty and the connectors are
blocked.
The batteries are not at full
power and have not been
installed correctly.
There is a problem with the
connectors in the battery
compartment.
The power dial has been
turned OFF and then ON.
Try this solution
Stop using the machine until
you ascertain the cause of the
skin irritation.
Do not put electrodes on
recently shaved skin, areas
that have suffered insect bites,
scrapes, acne or any open
wounds.
Wash the adhesive surface
of the pads gently with your
fingertips for about 3 seconds
under slow running water.
Use the device for a maximum
of 40 minutes per treatment
and no more than 3 times a
day.
Attach the 2 pads firmly to the
skin to ensure full contact.
Replace the set of pads.
Reconnect the body pads to
your skin or reconnect the
wire. Turn the Pain Therapy
Device off and then turn it
back on again to restart the
device.
Turn the power dial until it
clicks to the OFF position first.
Then turn the power dial back
to the ON position.
Examine and clean.
Replace the batteries or install
them correctly in the compart-
ment.
Try pulling the connectors
outward slightly using a small
pair of pliers.
Turn the power dial OFF and
then ON again.
DISPOSAL
1. The Pain Therapy Device, Foot
base and accessories should not
be thrown away with household
waste, but should be recycled by
you or the supplier.
SYMBOLS
Symbol Meaning
SERIAL NUMBER. This symbol will be accompanied by the manufacturer's
serial number.
CONSULT INSTRUCTIONS FOR USE.
Unique Device Identifier (UDI); the Application Identifier (01) represents the
device identifier (DI) ("0697074222XXXX"), the Application Identifier (11) the
production date/date of manufacture ("YYMMDD", with "YY" the last two digits
of the production year, "MM" the production month and "DD" the production
day), the Application Identifier (21) the serial number of the device ("WWWWW-
WWWW").
Medical device.
Indication of conformity with the essential health and safety requirements set
out in European Directives 0120 and 1639 – Notified body identification (SGS).
1639
DATE OF MANUFACTURE. This symbol will be accompanied by the date of
manufacture.
MANUFACTURER. This symbol will be accompanied by the name and the
address of the manufacturer.
AUTHORIZED REPRESENTATIVE IN THE EUROPEAN COMMUNITY. This
symbol will be accompanied by the name and the address of the authorized
representative in the European Community, adjacent to the symbol.
Dispose of separately from other household.
Type BF applied part (patient isolation from electrical shock).
2. Dispose of packing materials
appropriately in accordance
with the rules and regulations in
your area to prevent harm to the
environment.
15