Assembly And Detachment - ANEXO SPEED PRO Manual De Usuario

ASSEMBLY AND DETACHMENT OF
COMPONENTS ACCORDING TO MODEL
1. ASSEMBLY
SPEED PRO COVER (1)
Line up the 3 holes of the cover with the 3 shaft knobs. Turn these 90º in clockwise direction
(Figure 10).
RIGHT COVER SIDE OUTLET (2), LEFT COVER SIDE OUTLET (3)
Make sure that the side outlets are fully mounted and correctly in place (Figure 10).
The Side Outlets are not the same. Make sure you place the respective Side Outlet on the correct side.
Line up the lower part of the Side Outlet and turn towards the cover until the clip clicks in.
LOWER PRESSING UNIT (4), UPPER PRESSING UNIT (5)
Place the pressing units in the shafts (Figure 1).
Always mount the lower and upper pressing units of the same side at the same time to make it
easier to position them.
INJECTION PLASTIC SECURING KNOB (6)
Screw in the knobs to secure the pressing units and the feeder plate (Figure 1).
LEFT PEEL EJECTOR (7), RIGHT PEEL EJECTOR (8)
Place the ejectors on the respective side on the guides (Figure 1).
BLADE-HOLDER (9)
Place the blade carefully on its guide and push inwards (Figura 1).
35