Ryobi RBL26BV Manual De Utilización página 21

GB
F D E I
MAINTENANCE
WARNING
Before inspecting, cleaning, or servicing the
machine, shut off engine, wait for all moving parts
to stop, and disconnect spark plug wire and move
it away from spark plug. Failure to follow these
instructions can result in serious personal injury or
property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleumbased products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
REPLACING AND CLEANING THE AIR FILTER
(Fig. 6)
A wet or dirty air filter can affect the way the engine
starts, performs, and wears. The air filter should be
checked and cleaned after 8 hours of operation.
For best performance, the air filter should be replaced
once each year.
To clean the air filter(24):
Loosen the knob(25) on the air filter cover.
■
Remove the cover(23).
■
Lift the edge of the air filter carefully and peel it out.
■
Wash the air filter with warm, soapy water.
■
Rinse and squeeze to dry.
■
Reinstall the air filter.
■
NOTE: Make sure the filter is seated properly inside
the cover. Installing the filter incorrectly will allow dirt
to enter the engine, causing rapid engine wear.
Reinstall the cover.
■
Tighten knob to secure.
■
SPARK ARRESTOR
The muffler is equipped with a spark arrestor screen
inside muffler body. After extended use the screen can
become dirty and may need to have the muffler replaced
by an authorized servicing dealer.
WARNING
Never run the blower without the spark arrestor
P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT
English
in place. Failure to do so could result in a fire that
could cause serious personal injury.
C L E A N I N G T H E E X H A U S T P O R T A N D
MUFLER
Depending on the type of fuel used, the type and amount
of oil used, and/or your operating conditions, the exhaust
port and muffler may become blocked with carbon
deposits. If you notice low power from the blower, have
a qualified service technician check the exhaust port
and muffler for carbon deposits. Removing the carbon
deposits should restore performance to the blower.
FUEL CAP
WARNING
A leaking fuel cap is a fire hazard and must be
replaced immediately. Failure to do so could result
in a fire that could cause serious personal injury.
The fuel cap contains a non-serviceable filter and a
check valve. A clogged fuel filter will cause poor engine
performance. If performance improves when the fuel
cap is loosened, the check valve may be faulty or filter
clogged. Replace the fuel cap if required.
SPARK PLUG
This engine uses a Champion RCJ-6Y with 0.63 mm
(0.025 in.) electrode gap. Use an exact replacement and
replace annually.
WARNING
Be careful not to cross-thread the spark plug.
Cross-threading will seriously damage the
product.
STORAGE (1 MONTH OR LONGER)
Drain all fuel from the tank into a container approved
■
for gasoline. Run engine until it stops.
Clean all foreign material from the blower. Store it in
■
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Observe the local regulations for the safe storage and
■
handling of petrol. Excess fuel should be used up in
other 2-stroke engine powered equipment.
14
LV SK BG