Publicidad
Idiomas disponibles
Idiomas disponibles
14. Engage the "REVERSE ACTIVATION/DEACTIVATION" lever (8) underneath the steering wheel (Fig.7).
15. Press the drive pedal (9) (Fig.8) to start moving the machine in reverse.
16. Drive the machine down the ramp.
ATTENTION: during this operation, check there are no people or objects near the machine.
17. Set the main switch to its "0" position, and turn the key (1) a quarter turn anti-clockwise (Fig. 1).
18. Remove the key from the instrument panel.
19. Grip the handle (2) and turn the upper body (3) to its maintenance position.
ATTENTION: the following operations must be carried out by qualified personnel. An incorrect connection of
the connector may cause a malfunction of the device.
20. Disconnect the backup battery trolley connector from the main machine system connector.
21. Grip the handle (2) and turn the upper body (3) to its working position.
8
8
MACHINE SAFETY
To ensure that work is carried out in the best safety conditions, proceed as follows:
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
1.
Make sure the debris hopper is empty (if necessary, empty it). See
on page
49.
2.
Sit on the driver's seat.
3.
Insert the key (1) in the main machine switch on the right side of the steering column (Fig.1).
4.
Bring the main switch to position "I" by making a quarter turn clockwise with the key (1) (Fig.2).
N.B.: at switch-on, the control display visualises a series of pages, the last of which shows the machine
programming characteristics. See
5.
Make sure the central brush is in the idle position; if this is not the case, press the button (2) on the control
panel (Fig.3).
N.B.: when the central brush is in the idle position, the LED (3) on the button (2) is OFF.
9
9
"STARTING WORK" on page
29
29
"EMPTYING THE DEBRIS HOPPER"
45.
Publicidad
