Publicidad
Idiomas disponibles
Idiomas disponibles
RECHARGING THE BATTERIES
WARNING: the batteries must be charged prior to first use and whenever they no longer provide sufficient
power for the job to be carried out.
N.B.: before recharging, carefully read the Use and Maintenance Manual of the batteries you want to use.
N.B.: before recharging, carefully read the Use and Maintenance Manual of the battery charger you want to
use.
WARNING: HILLYARD disclaims all responsibility for any damage to property or injury to persons if the
batteries are recharged by an unauthorised technician or anyone non correctly instructed on how to perform
the task.
1.
Bring the machine to the battery recharging area.
ATTENTION: Park the machine in an enclosed place, on a flat and level surface; near the machine there
must be no objects that could either damage it, or be damaged through contact with it.
ATTENTION: the room where the batteries are recharged must be adequately ventilated to prevent the
accumulation of gases that leak from batteries.
WARNING: the place designated for this operation must comply with current regulations concerning safety at
work and current environmental protection regulations.
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
2.
Do everything necessary to ensure the machine is in a safe condition. See
3.
Grip the handle (1) and turn the upper body (2) to its maintenance position (Fig.1).
1
2
1
containing this instruction booklet,
the instructions.
ATTENTION: before connecting the battery box to the battery charger, make sure it is suitable for the type of
battery you want to charge.
N.B.: carefully read the user and maintenance instructions for the battery charger to be used for charging.
CAUTION: keep the upper body in the maintenance position throughout the battery recharging cycle, to
allow the gas fumes to escape.
C. Connect the battery charger cable to the power supply socket.
D. When the recharging cycle has been completed, disconnect the connector on the battery charger cable from
the connector on the battery power cable.
E. Connect the connector on the machine power cable to the connector on the battery power cable.
F.
Grip the handle (1) and turn the upper body (2) to its working position.
WARNING: the following operations must be carried out by qualified
personnel. Incorrect operations could result in machine malfunctions.
For versions without an on-board battery charger:
A. Disconnect the connector on the machine power cable from the connector
on the battery power cable.
B. Connect the connector on the battery charger cable to the connector on
the battery power cable.
N.B.: The battery charger coupling connector comes inside the bag
and must be assembled on the battery charger cables as indicated in
33
33
"DASHBOARD" on page
25.
Publicidad
